AGS - Automatic Gluing System

Doucet's AGS Automatic Gluing System is a modular system for loading staves to the glue applicator and forming panels that you can add to your existing Clamp Carrier or to integrate it to a new SRX Clamp Carrier with RT100.

1 year warranty Request a quote
AGS200 Pick up Zone
AGS200 Loading Side
AGS200 Pick up Zone

AGS100 model system included; 

  • Stave Lateral Chain Feeder

Staves are fed manually on the chains. Lateral chain feeder singulates each piece through the glue application device. Boards are automatically driven in sequence by a combination of two powered wheels located under the material and two top pressurized wheels.

  • Stave Glue Application

Staves are edge glued on one side through an extruder or just passing through if no glue is required based on settings parameters. The extruder is connected to a 12 gals pressurized stainless glue reservoir, or another tank supplied by the customer. UV sensor follows extruder to detect UV additive in the glue and advises with warning to operator if no glue is detected if option has been selected.

  • Load Accumulation Roller Conveyor

An accumulation conveyor for fresh panels to be loaded in the clamp carrier. Roller conveyor are made in three sections to allow the fork loader to lift the panel. Employee push the staves on four accumulation supports to prepare the load.

AGS200 model system included same as AGS100 except for the Load Accumulation Roller Conveyor that replace by Panel Forming Zone made of 6 chains rail deck where pieces coming out from the glue extruder are even-ended and side-shifted to build the panel full load.

When the panel load is completely made, the operator uses a panel loading device to manually moving the load in the clamp carrier.

  • Width measurement devices: The width detection sensors allow the capability to add parameters on interface to build load with dry joints for every individual panel.
  • Glue Detection: To activate the "no glue" detection capability, customer must be using UV additive mixed with the glue. Customer should validate with their glue manufacturer about such additives.
  • Vacuum Handling Arm : To carry staves loads from the AGS Automatic Gluing System  to the SRX Clamp Carrier. Can be installed on manual lifting device with electric hoist or similar devices.

Interested in this product?

You may also like

Download documents

Voir plusAGS100_Brochure Voir plusAGS200_Brochure

Request a quote