The RLT100 will allow you to boost the productivity of your panel assembly operations of at least 30% while keeping your labor costs under control as operator tasks are limited to loading and unloading panels into the carrier.
Features a first ground level moving carriage with a double pneumatic cylinder flattener that flattens the panels and tightens panels while a second carriage is automatically loosening clamps holding panels in the section above the carrier's workstation.
The RLT100's untightening device can have in option a laser sensor to open the clamps for the next required panel width.
Additionally, the SRX can be provided with 8" wide jaw clamps at fixed position. This feature increases the productivity of the operation between 15% and 20% by removing the non-value-added tasks of the operators to move clamps between panel length changes.
Pre-tightening cycle at lower pressure than setting pressure.
Operator Interface features :
Program special clamping sequences with saving capabilities ;
Setup mode to adjust pressure levels for tightening sequence ;
Pause cycle for panel inspection before rotation ;
Double kick of the panel flattener before tightening.
Operator interface to preset the opening of the clamp using a laser sensor (with Acme screw or fixed position 8'' clamps only).